Print a few pages at a time, as you need no need to lug that bulky binder around. You get it right away Zoom it, print it, save it, close it. At end of cable where shift nob is I placed an eyelet where the cable originally went,Pulled the new cable through taking out ALL the slack,Marked cable then crimped it,placed nut on screw.It works like new. Check it OutToday we'll be working on an MTD Yard Bug, commonly referred to as an MTD Beetle.It's the 1st time I've ever worked on one of. This is exactly like the original manual made for these model MTD Yard Machines Yardman Rear Engine Rider and Lawn Tractors the only difference is this one is not paper, and doesnt need to be shipped. ![]() ![]() I had the same problem with the shifter cable braking.They were very expensive to replace.My cable tube(the outer part with the adjustable nuts) was still good.The cable itself was broken.I went to the nieghborhood hardware store and bought a length of cable of the correct size.I then used an electrical eyelet at each end (the eyelet has place to slide wire into it then it get crimped to hold the wire,also it has a hole in it so a screw or bolt can go through to hold it in place.I connected an eyelet to one end of cable,2nd I fed the cable through the tube,3rd, I put a screw through the hole were the cable connect to the shift trans),4th placed the eyelet on the screw 5th then placed the nut on the screw.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |